CISCO SYSTEMS, INC.
14
working properly. On units with two channels, make
sure both channels have active video.
Audio
Source
ALARM
Audio has been silent on the selected audio source
for at least 15 seconds during encoding. Make sure
that audio is active on the source currently selected
on the Video page and that the cable for that source
is properly connected. On units with two channels,
make sure both channels have active audio. For
stereo analog audio, make sure audio is active on
both left and right. This alarm will return to OK after 1
second of audio is detected on the source during
encoding.
System
Temperature
HIGH
Contact Service personnel.
System
Fans
FAILURE
Contact Service personnel.
CPU Usage
HIGH
Change options to make the encoding simpler.
System
Memory
LOW
Change options to make the encoding simpler.
Disk Low
LOW
Check if encodes are being saved to the local disk.
Remove previously saved encoded files off the Media
Procesor unit. This alarm is triggered if available disk
space is < 2GB.
Disk Critical
LOW
Check if encodes are being saved to the local disk.
Remove previously saved encoded files off the Media
Procesor unit. This alarm is triggered if available disk
space is < 1GB.
Warm Boot
or Cold Boot
ACTIVE
A system reboot is in progress. This alarm will
display OK after 5 minutes have elapsed from LCD
Panel service start, or 10 seconds after encoding
service start, whichever is sooner.
If these steps do not resolve the alarm, contact service personnel.
For any alarm, checking the Ignore box will turn off the notification of that alarm on this
page, as well as the on the front panel display and in the log.
NOTE:
The audio alarm only sets or clears during encoding. During
encoding, if stereo analog audio is missing on either left or right, the
alarm will be triggered. On 2-channel units, missing audio or video
on either channel will trigger the alarm.
