Cirronet SEM2410, Руководство пользователя

Страница: 17 / 22


2000, 2001 Cirronet

Incorporated 14 M-2410-0007 Rev -
Radio Modem Configuration
The “radio” command provides access to several sub-commands that are useful in
configuring the WIT2410 in the SEM. The format for the radio commands is
radio
{A|B} <sub-cmd> [<sub-cmd-args>]
, where the
{A|B}
is either of the letters ‘A’ or
‘B’ used to specify to which radio the sub-command should be applied. The SEM uses
only the radio ‘A’ designation; the ‘B’ designation is for future use. The command
radio
{A|B} banner
can be used to display the banner from the radio. This is useful in
determining the unique ID of the radio and the version of firmware running in the radio.
Radio Commands
The radios in the SEM devices are set with factory defaults which should be sufficient for
most applications. For other applications, the following radio commands can be used to
fine tune the performance of the SEM.
Command Description
help
Displays command list
banner
Displays power on banner for the radio in the SEM
defaults Resets the radio parameters to the factory shipped values
maxremotes [
0..5]
Displays value currently in use
Sets the maximum number of subscribers the SEM will allow to
register.
Default = 5
network [
0..63]
Displays current SEM network number
Sets the network number for the SEM
Default = 0
param <rcmd>
[arg0,arg1…]
Sets other radio parameters. Should not be used unless instructed to by
Cirronet Technical Support
radio a
show Displays radio parameters that have been modified from factory
settings
help Displays list of sub-commands under the radio command.
banner Displays the power on banner of the radio inside the SEM.
defaults Replaces any modified parameters with the factory default values.
maxremotes Sets a limit to the number of remotes SEMS that a master SEM can have
registered simultaneously. The default is 5 but the parameter can range
from 1 to 5. If more than
maxremotes remote SEMs attempt to connect to
the access point, they will be denied.