4.3.- LED INDICATORS
4�3�1�- CirCAMP-4DP MODEL
The device features 17 LEDs:
Active Energy pulses
Pulse input
Cutting element
Relay outputs
PLC
CirCAMP-4DP
Figure 8:CirCAMP-4DP LED indicators�
4
to verify the
active energy,
one for each measurement element. The weight of the
LEDs is 10,000 imp/kWh.
The LEDs will remain lit when the current is lower than the energy meter start-up current.
Once the start-up current is exceeded the LEDs are turned off and emit impulses that are
proportional to the measured energy.
4
to indicate the impulse input of other supplies.
4
to indicate the circuit breaker status.
4
to indicate the relay output status.
1
to indicate the PLC communications status.
Table 7: Status LEDs: CirCAMP-4DP�
LEDs
Cutting element
Power on
The power supply is connected to the electrical network
Power off
The power supply is disconnected from the electrical network
Pulse input
Calculation of impulses of other supplies: water, gas, etc.
Relay outputs
Power on
Relay connected.
Power off
Relay disconnected.
16
CirCAMP-4DP, CirCAMP-2IP
Instruction Manual
Содержание CirCAMP-2IP
