Sicon-8 Technical Manual
CircuitWerkes, Inc.
28
94 – Remote/Local mode toggle
- If remote toggling is enabled in the system setup menu, you
can enter your special remote toggle password here twice in a row followed by the # key, each time,
to toggle between remote & local mode. While this function can be used to put the Sicon-8 back
into remote mode when it has been accidentally left in the local position, only a senior administrator
that has personal knowledge that there is no one at the remote site should ever make the decision to
enable the remote mode. The special password for this function should always be changed from the
default and never given out to anyone other than responsible senior management. You must have
administrator access to operate this function.
95 – Audio monitor
- turns on the audio input and feeds it down the phone line for 15 seconds. If
audio control is disabled (audio input is normally muted), then this will unmute the audio input for 15
seconds, or until a DTMF tone is entered by the user. If audio control is enabled, this simply toggles
the audio mute line. The user should exercise caution in this case because if they are controlling the
Sicon through the audio input (or with the cell-phone interface), then executing this command will
mute the input, preventing them from being able to further control the Sicon.
96 – Report Firmware Version
97 – Logout previous user
- Lets you login with a different password. You can use this to
increase or decrease the current access level of the Sicon-8.
98 – TAD Mode
- Briefly disables Sicon-8 auto-answer feature so that you can use other
answering devices that share a phone line. To use, enter 98 followed by a digit for the number of
minutes that the unit is to wait before answering. If no digit is entered following the 98, the Sicon-8
will default to 2 minutes. Entering a # adds 10 minutes.
99 – Immediate hang-up command
- The Sicon-8 will say “good bye” & immediately disconnect.
Содержание Sicon-8
Страница 2: ......