CircuitWerkes Sicon-8, Руководство по эксплуатации и техническому обслуживанию, Страница: 22 / 32

Sicon-8 Technical Manual CircuitWerkes, Inc.
22
91 – System Setup Cont’d
An asterisk (*) followed by a single digit sets a pause of 5 seconds multiplied by the digit that
was entered. For instance *6 sets a 30 second pause. Note that *0 sets a pause of 1
minute.
A double asterisk (**) is used to store a single asterisk in the dialing sequence.
An asterisk followed by a pound (*#) is used to store a single pound (#) in the dialing
sequence.
Note that pauses, pounds and asterisks take two DTMF tones to create them and so count
as two of the 32 storable digits for each memory location.
73 – Enable or disable individual phone numbers.
This function is used to avoid reprogramming channel alarms when someone on the warning alarm
dial lists is to be unavailable. Disabling that memory does not erase the memory but keeps that
number from being dialed when a warning alarm or alarms occur. A zero disables and a one
enables.
74 – Set the expansion chassis.
If you have an optional 8 channel expansion chassis, enter a one (1) to enable it or a zero (0) to
disable.
75 - Enable/disable remote toggling of Remote/Local mode
When the Sicon-8 is in local mode, it will not answer an incoming phone call until after the number of
rings that has been set in #79 below (Default=20). If the remote toggling is enabled See #94 of the
system setup menu), you can use your remote toggle password (default = 1379) to change from
local mode to remote mode. Default for this function is disabled for safety reasons. Enter 0 to
disable and 1 to enable.
76– Global enable/disable critical alarm dial-out.
This setting supercedes the individual alarm settings and allows you to mute or unmute all critical
alarms. The individual alarm settings for each channel are not affected. Entering a 0 will mute all
warning alarms. Entering a 1 will allow critical alarms to be handled normally. Default = enabled.
76 - Enable/disable cell-phone interface.
Enter a 0 to disable the cell phone audio interface or a 1 to enable the interface. Default = disabled
78 - Set number of rings until answer in Remote mode
Enter a two digit number from 01 to 99 to set the number of rings that the Sicon-8 will wait before
answering an incoming call. Default = 2
79- Set number of rings until answer in Local mode
Enter a two digit number from 01 to 99 to set the number of rings that the Sicon-8 will wait before
answering an incoming call when it is in the local mode. Default = 20.
Setup: The Sicon-8 beeps once. Enter a two-digit phone dialer memory location (01 thru 20). Sicon beeps. Enter
the telephone number to be dialed followed by the #. Sicon beeps twice ending this sequence.