CircuitWerkes Sicon-8, Руководство по эксплуатации и техническому обслуживанию, Страница: 25 / 32

Sicon-8 Technical Manual CircuitWerkes, Inc.
25
91 – System Setup Cont’d
88 – Programming Time/Date Events & Actions continued
Setting the event time:
Step 1. Enter the two-digit hour (military time, midnight is '00')
Step 2. Enter the two-digit minute
Step 3. Enter the two-digit month
Step 4. Enter the two-digit date
Step 5. Enter the two-digit year (To repeat an event every year, enter a single asterisk (*) in
step 5).
Step 6. Enter the two-digit period. Here you can choose whether an event runs only once or
if it re-occurs on a schedule that you will set.
-
Enter '00' if the event is non-periodic, i.e., it occurs only once. If the event is non-periodic,
you have just created a one-shot event as described in mode #1 above. You are now done
with the time and date part of this event’s setup and the Sicon will beep twice. You can now
go to the ‘Setting the action’ section below.
Step 7. If an event will re-occur periodically, you must tell the Sicon-8 how often the event will
happen. This consists of two parts: Entering the period and setting the period’s units
(minutes, hours, days, etc.).
- If the event occurs every seven days, for instance, enter '07'.
Note: this value cannot exceed 60.
Step 8 If the period is non-zero, enter the units that the period is measured in:
- minutes: 0
- hours: 1
- days: 2
- months: 3
Step 9. If period is non-zero, enter the two-digit duration:
-
Enter '00' if the event does not expire. The Sicon-8 will beep twice indicating that you are
done with this event’s setup.
Step 10. If you did not enter a 00 duration
-
If the event should expire in 12 months, enter '12'. Note: this value cannot exceed 60.
Step 11. If period is non-zero AND duration is non-zero, enter the units that the duration is
measured in:
- minutes: 0
- hours: 1
- days: 2
- months: 3
Go to Setting the action for a time event or sequence on the following page