CircuitWerkes Sicon-8, Руководство по эксплуатации и техническому обслуживанию, Страница: 13 / 32

Sicon-8 Technical Manual CircuitWerkes, Inc.
13
the phrases stored in these locations, though changing the language would be just fine. For
example, if the word "truck" were recorded into the location where "four" is normally stored, then the
Sicon would read back "truck" "point" "eight" "nine" "kiloWatts". Obviously, this doesn't make much
sense.
It is usually only necessary to re-record the phrases corresponding to the Meter Labels, Status
Labels, Unit Labels, and Site Label, since each user will configure their Sicon differently. Meter
Labels are spoken immediately before reading a meter value, so if Meter 1 corresponds to the
Transmitter Power Output, then you would record "Transmitter Power Output" into Meter Label 1.
Similarly, Status Labels are spoken before a given channel's status value is read. Each channel has
its own distinct Meter and Status Labels. A Unit Label is spoken immediately after the meter value
has been read, and is used to identify the units being measured. In the above example, the Unit
Label is "kiloWatts". The Site Label is the phrase which is spoken right after the Sicon answers the
telephone line. Some users may want to record silence into this location, so a malicious caller will
not recognize the need to enter a password.
The factory programmed defaults for the Sicon-8 are as follows:
Passwords
DTMF Super-Admin PW = 6736
Serial Super-Admin PW = 12345678 (ASCII characters)
Remote/Local Toggle password = 1379
* Meters
All meters are configured for direct linear mode with units set to volts
* Status
Status polarity is set to normal
Status alarms are set as warning, but they're disabled
* Alarms
Global alarms are
enabled
All individual alarms are disabled
Alarms are not configured
* Phone numbers
Master phone number list and individual alarm lists are cleared (no valid phone numbers)
* Other settings
Remote ring limit = 2 rings
Local ring limit = 20 rings
Max. number of incorrect DTMF passwords before hang-up = 3
Remote/Local toggle is disabled
Unit is not expanded (no SX-8 Chassis Attached)
Alarm dial-out is enabled
Cell-phone interface is disabled
* Timers (NOTE: These are currently not configurable)
DTMF inactivity timer = 2 minutes
+ The amount of time that can elapse without receiving a valid DTMF tone until the unit
hangs up
Power-up timer = 5 minutes
+ The amount of time after power-up until the unit begins checking alarms
Wait for reference timer = 1 minute
+ The amount of time to elapse after requesting a reference reading until the reference
reading is actually taken