Circontrol Wallbox eNext S, Руководство по установке

Страница: 9 / 32

05
• Charge Point must not be installed
in areas where potential risk of
explosions are.
• Do not install the Charge Point
where falling objects may damage
the equipment.
• The surface where the Charge
Point is placed must withstand the
mechanical forces.
• This unit is no shall be used for
anything other purpose than
electric vehicle charging modes as
are expected in IEC 61851.
• Do not modify this unit. If
modified, Circontrol will reject all
responsibility and the warranty will
be void.
• Comply strictly with electrical
safety regulations according to your
country.
• Do not use any adapter, except those
approved by the EV manufacturer.
• Do not perform any repair o
manipulation of the unit while it is
energized.
• Only trained and qualified personnel
should be able to access to low-
voltage electrical parts inside the
unit.
• Check the installation annually by
qualified technician.
• Remove from service any item
which have a fault that could be
dangerous for users (broken plugs,
caps that don’t close...).
• Use only Circontrol supplied spare
parts.
• Do not use this product if the
enclosure or the EV connector is
broken, cracked, open, or shows
any other indication of damage.
I M P O R TA N T C H A R G E P O I N T S A F E T Y I N S T RU C T I O N S
Read carefully all the instructions before starting in order
to ensure properly installation of the Charge Point.
Before installation
Refer to chapter "6 - TECHNICAL DATA" for more information about environmental
installation conditions.
The Charge Point is designed for installation in indoor and outdoor areas. For each of
the different conditions of installation, the unit must be installed safely and assuring the
adequate protections.