Circontrol Wallbox eNext S, Руководство по установке

Страница: 10 / 32

06
Wallbox eNext Series Installation Manual
E L E C T R I CA L W I R I N G C O N S I D E R AT I O N S
Take into consideration this section before starting
wiring connections of the Charge Point.
1 — E L E C T R I CA L P R OT E C T I O N S
Charge Point may not include elements of electrical protection.
If this equipment has internal electrical protections, are installed in each socket-
outlet for the protection of the user against an electrical failure, according to the
international standard IEC 61851-1:2017.
In order to guarantee the total protection of the users and the installation (power
supply line included) in front of any electrical hazard, install a main circuit breaker
(MCB) and a residual current device (RCD) upstream of the Charge Point is mandatory.
These electrical protections and the rest of the installation have to be aligned with
the local and national rules. The selectivity of the protections has to be guaranteed
at all times.
2 — P OW E R S U P P LY L I N E D I M E N S I O N I N G
The dimensioning of the input power supply line of the Charge Point must be checked
by a qualified electrician. Note that several factors such as cable length between
distribution board and Charge Point, maximum output current of the Charge Point
may influence the criteria of cable selection.
In such cases, increasing the cable cross-section is required to adapt the temperature
resistance of the power supply line.
3 — M A X I M U M O U T P U T C U R R E N T
Please refer to chapter "6 - TECHNICAL DATA" to consult the default factory settings
from maximum output current of the Charge Point.
If the power supply is lower than maximum output current, it is necessary to adjust the
nominal current. To perform this adjustment, please refer to the INSTRUCTION MANUAL.
This value may vary depending on the model.