Document NO. M-7E-EM-English
PAGE
Page 23 of 25
Engineer Manual-Trouble Shooting
VERSION
B
4.
Other Information
4.1.
Real Speed Do Not To Fit In With Display Speed
Step
illustrate
Auxiliary Photo
1
To START and operate the speed to the
position where has problem.
2
To measure the running belt speed to
compare to display speed.
Is there really different?
The accuracy is normal if speed tolerance
between ±10% display speed.
3
To execute the engineer mode ONE for speed
calibration and check speed parameter is
normal, if speed parameter abnormal,
please replace the speed sensor.
Refer to:
2.3『Speed Sensor』
3.1『Engineering Mode ONE: Factory
Settings』
4.2.
No Any Display On Console(No Power)
Step
illustrate
Auxiliary Photo
1
To check the fuse where near the AC source
power switch is start or not, if the fuse
started please to press draw back for reset
the power.If every is fine after reset
power, it to mean the load is to big, need
to do the maintenance or replace the
running belt and deck.
2
If fuse do not start, please open the motor
cover and check the power supply normally
from interface PCB.
Refer to:
2.1『Interface PCB』
3
If interface PCB is ok after check, please
check the console wire connection.
Refer to:
2.2『Console Wire』
4
If console wire check is ok, to check the
voltage where from the interface PCB by
multi-meter, if got voltage, please
replace the console PCB.
Gray+
Purple-