Cino eC Pro, Руководство по установке и обслуживанию, Страница: 44 / 53

MAN1010119 rel. 01 dated 30.01.2014 page no. 44 of 52 page
www.rheavendors.com tel: 0039 02 966 551 fax: 0039 02 96 55 086 e mail: rheavendors@rheavendors.com
rheavendors group's sole property
cino eC PRO by
OFF 10
OFF 14
OFF 14 B
OFF 16
OFF 17
OFF 17 A
OFF 24
OFF 24 A
OFF 24 B
OFF 31
OFF 31 A
OFF 31 B
OFF 31 C
OFF 31 D
OFF 77
OFF 80
OFF 80 4
OFF 80 6
OFF 80 7
OFF 80 8
OFF 80 C
OFF 80 D
EAROM
water inlet
pressure boiler
programming keyboard
keyboards
selection
power supply unit
24 V dc
24 V dc
espresso coffee water
temperature
temperature
pressure boiler probe
time
CPU
MDB change giver
pipes
validator
pipe
memory
coin
coin
stored data are not consistent (reading or writing error) and the overall
operation of the vending machine may be otherwise than expected;
if water is not reloaded after six dispensing cycles, error 14 is triggered;
even a water inlet pressure value other than the pre-set one, may cause
this error, thus filling in the pressure boiler in excess and providing for a
number of dispensing cycles higher than the pre-set one; if selections are
dispensed with a limited water quantity, the error is more likely to occur;
the programming keyboard inside the machine has a short-circuited key or
it has been pressed too long; if pressed too long, the manual release
button of cups turrets may cause this error;
a button appears as if it were constantly pressed;
the actual 24 V dc voltage value is higher than the tolerated one;
the measured 24 V dc voltage value is below the admitted threshold or
totally absent, e.g. because a fuse has tripped; find out and remove the
causes that have produced this error before powering on the machine
again;
the pressure boiler water temperature is higher than the programmed
value;
water fails to achieve the set temperature;
the temperature probe is interrupted or its electric connector is detached;
the temperature fails to achieve the programmed value within the admitted
time limit;
the "clock" function is not properly performed; the buffer battery might be
low; after having restored the function, carefully check the clock-related
machine functions: happy hour, time bands, ... that might have been
compromised by the lack of time references;
a pipe sensor is not properly working;
validator not inserted or disconnected;
a coin pipe is not properly working;
ROM with reading/writing error;
coin locked in the acceptance path;
attempt at fraud and coin removal;