
MAN1010119 rel. 01 dated 30.01.2014
page no. 24 of 52 page
www.rheavendors.com tel: 0039 02 966 551 fax: 0039 02 96 55 086 e mail: [email protected]
rheavendors group's sole property
cino eC PRO by
08.03. washing
transportation, storage and installation conditions can not provide
for immediate utilisation of the vending machine and it is
recommended to perform a complete wash cycle before using the
vending machine;
press the programming button (see 05.14.);
the display shows alternatively the messages:
attention
the vending machine is supplied and running to all effects; the
mobile parts of the coffee brewer will be handled; act extremely
carefully;
arrange a cup beneath the nozzles; the machine will dispense a
pre-fixed water quantity for each wash cycle;
press “4” to enable the wash cycle of the water circuit (boiler,
tubes, mixing bowls, ….);
follow the display instructions that require the operator to must be
sure that the drip tray is empty and the machine is hydraulically
connected;
the display shows:
key “1=pb” will dispense water through the coffee brewer;
selection “2=mx1” will do it in the mixing bowls for instant
products; key “4=water” in the hot water outlet hole to the cup;
key “8=hc.” will carry out the sanitary wash cycle for the brewer
and then the wash cycles for the mixing bowls and the direct water
circuit; (see 09.04.);
repeat the operation for some times to rinse the whole water circuit
of the machine; during the wash cycles, the display will show the
circuit that is being washed;
a special wash cycle is intended to sanitise the coffee brewer by
using specific cleaning products in tabs; press key “8=hc. ”, the
display shows:
after having positioned the cup beneath the dispensing nozzles, put
a tab in the coffee brewer chamber; press “10”, follow the display
instruction and wait for the wash cycle to automatically come to an
end;
attention
ca. 100 cc. water will be dispensed for each one of the six wash
cycles;
at the end of the sanitary wash cycle of the coffee brewer, the
machine will also wash the mixing bowls and the direct water
circuits; for this reason, make sure that at least a couple of cups
can be placed beneath the product nozzles;
power off the vending machine by means of the service key;
arrange it in its support (see 05.13.); power off the main switch at
the back of the machine (see 05.08.);
CLEANING
butt.: 1=pb 2=mx1
4=water 8=hc.
Cleaning
Brewer
Cleaning
mixer “N”
Cleaning
water
or
or
1= PROGRAMMING
3= TEST VEND
2= DATA 4= CLEAN
5= MAINTENANCE
driptray
inside? 10= START
Water OK ?
10= START
put pastille and
push P10=START
CLEANING
butt.: 1=pb 2=mx1
4=water
8=hc .
tab dissolve
4:30min
1:15
min
cleaning brewer
6 mal
1
/6
Содержание eC Pro
Страница 53: ......