CIGWELD TRANSarc 130i, Руководство по обслуживанию

Страница: 17 / 86

MANUAL 0-5280 2-1 INTRODUCTION
TRANSARC 170i
SECTION 2:
INTRODUCTION
2.01 How to Use This Manual
To ensure safe operation, read the entire manual, includ-
ing the chapter on safety instructions and warnings.
Throughout this manual, the word WARNING, CAU-
TION and NOTE may appear. Pay particular attention to
the information provided under these headings. These
special annotations are easily recognized as follows:
!
WARNING
Gives information regarding possible per-
sonal injury. Warnings will be enclosed in a
box such as this.
CAUTION
Refers to possible equipment damage. Cau-
tions will be shown in bold type.
NOTE
Offers helpful information concerning certain
operating procedures. Notes will be shown
in italics
You will also notice icons from the safety section ap-
pearing throughout the manual. These are to advise you
of specific types of hazards or cautions related to the
portion of information that follows. Some may have
multiple hazards that apply and would look something
like this:
2.02 Equipment Identification
The unit’s identification number (specification or part
number), model, and serial number usually appear
on a nameplate attached to the machine. Equipment
which does not have a nameplate attached to the
machine is identified only by the specification or part
number printed on the shipping container. Record these
numbers for future reference.
2.03 Receipt of Equipment
When you receive the equipment, check it against the
invoice to make sure it is complete and inspect the
equipment for possible damage due to shipping. If there
is any damage, notify the carrier immediately to file a
claim. Furnish complete information concerning damage
claims or shipping errors to the location in your area
listed in the inside back cover of this manual. Include
all equipment identification numbers as described above
along with a full description of the parts in error.
Move the equipment to the installation site before
un-crating the unit. Use care to avoid damaging the
equipment when using bars, hammers, etc., to un-crate
the unit.
2.04 Description
The Cigweld Transarc 170i is a self contained single
phase multi process welding inverter that is capable of
performing MMAW (Stick) and GTAW (Lift TIG) weld-
ing processes. The unit is equipped with an integrated
voltage reduction device (VRD applicable in stick mode
only), digital amperage/voltage meter, and a host of
other features in order to fully satisfy the broad oper-
ating needs of the modern welding professional. The
unit is also fully compliant to Australian Standard AS
60974.1 and IEC 60974.1.
The Transarc 170i provides excellent welding perfor-
mance across a broad range of applications when used
with the correct welding consumables and procedures.
The following instructions detail how to correctly and
safely set up the machine and give guidelines on gaining
the best efficiency and quality from the Power Source.
Please read these instructions thoroughly before using
the unit.
2.05 Transportation Methods
!
Disconnect input power
conductors from de-energized supply line before
moving the welding power source.
Lift unit with handle on top of case. Use handcart or
similar device of adequate capacity. If using a fork
lift vehicle, secure the unit on a proper skid before
transporting.