M-97RG2 Hardware Installation Manual
11
3.4. Uninstall the Gateway
For uninstall the Gateway on the wall:
1. Plug out the cables connector.
2. If necessary, remove the screw on the brackets, and take off the brackets.
For uninstall the Gateway on the desktop:
4. Plug out the cables connector.
4. Services enabled
4.1.
Connecting Power
For AC power supply
1. Plug the 2-pin 12V DC power connector of AC power connector to ONT AC power interface.
2. Plug the input of electricity cable into a live AC outlet.
3. Verify that the power (PWR) LED on the Gateway is lit green indicating that local power is on
and voltage is good.
4.2.
Connecting Ethernet Interface
1. Locate the premises’ Ethernet LAN cable.
2. If the cable is not terminated, follow local practices to attach an RJ-45 connector. Table 8
shows Ethernet RJ-45 connector wiring information.
3. Plug the Ethernet cable into the Gateway RJ-45 Ethernet port.
4. Repeat step 2-3 as needed to connect additional Ethernet cables.
Table 1 Ethernet RJ-45 connector wiring pattern
Pin
Color
Signal
Pin
Color
Signal
1
Orange/White
Tx +
5
Blue/White
BI-
2
Orange
Tx-
6
Green
Rx —
