CID TRBC162672, Руководство пользователя

Страница: 25 / 68

Xtreme Tree Reaper Brush Cutter
May 2022
25
General Operating Tips
1. LEARN what the cutter head looks like in a level position when you are seated
in the skid steer. Knowing what a level cutter head looks like will prevent you
from damaging the cutter blades if you cut too close to the ground.
2. SLOW down the skid steer if the engine “bogs” down or if the cutter speed is
too slow because of too much load.
3. If you feel a strong vibration while cutting, slow the skid steer down and see if
the vibration stops. If not, stop the brush cutter, turn off the skid steer engine
and investigate the cause. Refer to the “Troubleshooting Chart” on page 46.
4. ALWAYS be aware of your surroundings and pay attention to obstacles and
terrain in front of you.
Use the skid steer loader’s lift and tilt controls to adjust brush cutter height
and level. Refer to your skid steer operator’s manual for instructions on these
controls.
3.7 Cutting Operations
Adjusting Cutter Height & Level
When cutting dense or heavy material, adjust the level of the cutter
deck so the front of the cutter is 1 inch lower than the back of the
cutter. This will prevent material from “balling” .
Cutting tree branches with the cutter in an elevated position could result
in Death or Serious Injury if the skid steer becomes unstable. Always use
brush cutter with the safety chain installed.
To avoid serious injury or death from flying branches and debris, install safety
chain to limit the height of the brush cutter.