CID TRBC162672, Руководство пользователя

Страница: 24 / 68

Xtreme Tree Reaper Brush Cutter
May 2022
24
After starting skid steer, lift attachment 6 inches off the ground surface:
1. Set skid steer engine RPM to just above idle.
2. Switch on the auxiliary hydraulic circuit.
3. Allow the cutter to run for 30 seconds to purge air from the system, then switch off the
auxiliary hydraulic circuit and allow cutter blades to come to a complete stop.
4. Lower the brush cutter to the ground, shut off skid steer engine and exit the cab.
5. Check the hydraulic oil level in the skid steer, add oil if necessary.
6. Inspect the brush cutter hydraulic plumbing for noticeable leaks. Fix before continuing.
7. Restart skid steer, set engine RPM to slightly above idle.
8. Raise brush cutter off the ground and switch on the auxiliary hydraulic circuit.
9. Once brush cutter ramps up to speed, increase skid steer engine to full throttle.
3.6 Initial Use Procedure Cont.
To avoid serious injury by hydraulic fluid injection into your skin, never use your hand
or other body parts to locate a hydraulic leak. Detect leaks with a piece of wood or
card board.
6 in