Christie RPMSP-D120U, Руководство по установке

Страница: 12 / 51

Section 2: Installation & Setup
2-4 RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide
020-100038-02 Rev. 1 (09/08)
Figure 2.2. Remove Lamp Changer Lock Screw
Modify projector configuration (if required)
If you are planning on using your projector for lens-horizontal projection then
you must change its configuration. The L-shaped bracket and M6 screws shipped
with the projector are needed to complete this configuration change.
1. Ensure the projector is not plugged into AC.
2. Disconnect all cable connections made between the light engine and
electronics module. All disconnects should be made on the light engine
side.
3. Remove the 6, M4 screws securing the light engine module to the 6-axis
adjuster.
Figure 2.3. Loosen Light Engine
4. Lift the light engine off the adjuster and set aside.
5. Take the L-shaped configuration bracket and align the shorter end with
the mounting holes in the adjuster base, as shown in Figure 2.4. The long
vertical part of the bracket will face the same side as the connectors on
the electronics module.
Step 2 h