Section 2: Installation & Setup
RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide
2-15
020-100038-02 Rev. 1 (09/08)
If you want to use an extra video source in
addition to the video source(s) connected at
input 3 or input 4 connect either a Composite
or S-video source to input 1 as shown.
NOTES: 1)
Do not simultaneously connect
composite and s-video to
INPUT 1
.
2)
You can
switch between video sources connected at
INPUT 1
and
INPUT 3
or
INPUT 4
.
Optional input modules allow you to increase your total number of inputs and/or
accommodate different signal types, whether analog or digital. Install in the area
labeled
INPUT 5.
Options include:
•
RGB 500 Input Module
•
RGB 400 Active Loop Thru Input Module
•
RGB 400 Buffered Amplifier Input Module
•
PC250 Analog Input Module
•
Serial Digital Input Module
•
DVI Input Module
•
Dual SD/HD-SDI Module
NOTE:
See
Appendix F, Optional Input Modules
for a brief description of
each interface.
As an alternative to the projector’s keypad or remote, you may wish to
communicate with the projector using a PC or other controller. Such a device
sends commands and receives feedback via serial links (RS232 and RS422),
Ethernet or GPIO communications to the projector, all described below.
As desired, direct the projector’s IR remote keypad towards the display screen
or the projector’s IR sensor. Alternatively, connect a wired (tethered) version of
the remote to the RCA jack labeled
REMOTE
on the projector’s input panel.
Note that response to a wired keypad must also be enabled in the
Communications
menu—see
3.6, Adjusting System Parameters and Advanced
Controls
for more information.
Extra
Video
h
Figure 2.17. Connecting Extra
Video
Optional
Inputs
h
2.5 Connecting
Communications
Remote
Keypad
h
Содержание RPMSP-D120U
