Christie RPMSP-D120U, Руководство по установке

Страница: 16 / 51

Section 2: Installation & Setup
2-8 RPMX-RPMSP-D120U & RPMSP-D275U Setup Guide
020-100038-02 Rev. 1 (09/08)
located in the upper right corner of the input panel. Use the DVI-I connector at
INPUT 2
to connect analog or digital display signals. Connect composite video to
INPUT 3
and S-video to
INPUT 4
. NOTE: One of the available optional input
modules can be installed at
INPUT 5
for additional connections.
Refer to 2.4 Connecting Sources for more details on connecting a specific source.
Turn the projector ON and select a source
WARNINGS
The North American rated line cord is provided with
this projector. For all other regions, ensure that you
are using a line cord, power plug and socket that
meet the appropriate rating standards.
Before powering ON, ensure the lamp changer lock
screw has been removed. Failure to remove this screw
can cause damage to the projector and the lamp
changer assembly.
Do not use a line cord that has been damaged.
1. Plug an approved line cord into the projector’s AC receptacle, which is
located on the electronics module. Then plug the 3-pronged end of the
line cord into a grounded AC outlet.
NOTE:
The outlet must be near the
equipment and easily accessible. Use only the line cord provided with the
projector or a power cord of appropriate ratings that comply with
regional standards.
Do not use a line cord or AC supply not in the
specified voltage and power range. See Section 6 – Specifications for
projector power requirements.
2. Press for two seconds to turn the projector on. As the projector
begins initialization, an active pattern of segments appear in the LED
status display window that is located with the built-in keypad. Do not
enter a keypad command until “On” appears in the status display,
otherwise the command will be ignored.
3. Press one of the input keys on the remote to select and display the image
for the source connected in Step 4.
NOTE: For more information on the
keys available on the remote and their function, refer to Section 3.
NOTE: The projector enforces a 60 second wait period from the time the
projector is powered down and back up again .
Step 5
h