Christie M Series, Руководство пользователя

Страница: 102 / 168

3-56 M Series User Manual
020-100009-05 Rev. 1 (09-2010)
Section 3: Operation
AUTO INPUT SEARCHING
When enabled, the system will continually search for the next valid signal when no signal is present or when
loss of sync occurs on the current user selected input. In the case of multiple signals to choose from, the order
is based on slot, followed by inputs on that slot.
.
HDMI OUTPUT LOOP SOURCE
Configure the HDMI output options.
Select
Direct Loop to directly pass-through the HDMI input signals (from the same Twin HDMI Input Card).
The Input1 signal is looped to Output1 and the Input2 is looped to Output2.
Select
Main/Secondary Loop to loop the Main & secondary video to the outputs (regardless of which card
these signal originate from). The Main video signal is looped to Output1 and the Secondary video signal is
looped to Output2.
Select
Disable to shut off the HDMI outputs completely.
STANDBY ACTIVE LOOP-THROUGH
Enable this checkbox in situations where a Twin HDMI Input card is being used to loop signals out to another
projector.
Standby Active Loop-Through ensures that video signals continue to be looped out when the
projector enters standby power mode.
NOTE
: When the projector is in standby mode (and Standby Active
Loop-Through is selected), limited channel control is available - inputs can be switched, perform auto setup
and some limited input settings can be modified.
3.11 Status
The read-only Status menu lists a variety of details about the standard and optional components currently
detected in the projector. Refer to the Status menu for versions of hardware and software installed, the type
(size) of lamp, the hours logged in total and for a specific period (such as a rental period), and for your
projector model name and serial number. In addition, the
Status menu identifies the current channel, its
location, its frequencies and other details.
3.12 Using Multiple Projectors
IMPORTANT!
When working with more than two projectors, work left to right, top to bottom.
When an installation requires multiple projectors, use the RS-232 serial ports to daisy chain the units together
and control the group with a single keypad or a computer/controller connected to the first projector. In such a
network, you can choose to broadcast commands to the entire group, or use the
P
ROJ
key as desired to limit
responses to an individual projector.
Alternatively, you may want to add projectors to a hub on an Ethernet network. See
Figure 2-25 Mixed
Network for full routing details.