Communicating with
Boxer 4K
Understand the information and procedures for communicating with Boxer 4K from a remote location.
Connection and use
Once you have connected your computer to either the RS232 IN port (depending on which standard is
supported by your computer) or to the Ethernet port on Boxer 4K, you can remotely access controls
and image setups, issue commands or queries, and receive replies.
Use these bidirectional messages to:
•
Control multiple projectors
•
Obtain a projector’s status report
•
Diagnose performance problems
Refer to the User Manual provided with the projector for all cable requirements and other connection
details.
Some commands are operational only when projector is powered up.
Connecting to a computer or server
Communicate with a remote computer, server, or an existing network using a RJ-45 cable.
The RS232 port located on the IMXB faceplate uses Christie-proprietary protocol and is intended for
Christie accessories or automation controllers only.
1. Use an RJ-45 cable to connect the Ethernet hub or switch to the Ethernet port, located on the
projector IMXB faceplate.
2. When using the Christie serial protocol over Ethernet, connect to port 3002.
3. For applications or equipment using serial communications, use the Christie-proprietary serial
protocol to communicate with the RS232 port on the IMXB faceplate.
Configuring the RS232 port
Configure the RS232 port to send Christie serial commands using a standard RS232 serial cable.
1. Select Menu > Communications > Projector Communication.
2. Use the down arrow to select Baud Rate.
Boxer 4K Serial API Commands Technical Reference
5
020-101697-05 Rev. 1 (07-2017)
Copyright
©
2017 Christie Digital Systems USA Inc. All rights reserved.