Christie 4K35-RGB, Техническое описание

Страница: 13 / 67

Maximizing message integrity
For additional reassurance and/or maximum message integrity, insert one or two special characters.
Message
requirement Description
Acknowledgments For assurance from Christie (or group of projectors) that a set message has been
processed, request an acknowledgment.
The acknowledgment is returned after the message has been received and fully executed
by Christie (such as in the case of a source switch it is not sent until the switch is
complete). If the message cannot be executed for some reason (such as invalid
parameters, time-out, and so on) a NAK is returned instead (not-acknowledge).
Requesting an acknowledgment serves no purpose when included in a request message,
as the acknowledgment is redundant to the actual reply from Christie . However, if
requested, the dollar sign ($) acknowledgment from Christie follows the reply.
There are two types of acknowledgments:
• Simple Acknowledgments—Insert a dollar sign ($) character just after the start code
bracket. This only returns a $. This only returns a dollar sign ($) on success, or a
caret (^) on failure (NAK).
• Full Acknowledgments—Insert a hash (#) character just after the start code bracket.
This returns the message sent, as a reply.
This is a quick way to confirm success with set messages and is useful with long distance
communication links or where the projectors and/or images are not visible from the
controller. Acknowledgments can also be a type of flow control.
Checksums For maximum message integrity, add a checksum character ampersand (&) just after the
start code bracket. You must also include the correct checksum total (0-255) just before
the end code bracket. Make sure to add a space before the calculated checksum to
separate it from the last data parameter:
The checksum is the low byte of the sum of the ASCII values of all characters between the
start bracket and the beginning of the checksum, but not including either. It does include
the space in front of the checksum.
Calculate the checksum for the above set contrast to 64 command as follows:
CHECKSUM EXAMPLE = & + c + o + n + 6 + 4 + ‘space’
= 26h+63h +6Fh +6E h +36h +$34h +$20h
= 01F0h
= F0h when only the low byte is used
= 240
Christie collects all of the message bytes as defined in the first byte of the
message, then creates its own checksum value for comparison with the checksum included
in the controller’s message. If the values match, the message is considered to have been
correctly received; otherwise, the message is discarded.
Note the following:
• h indicates a hex number.
• If a request message has a checksum, so does the reply.
• If using both acknowledge and checksum, either character can occur first.
Communicating with Christie
Christie Technical Reference–Serial Commands 13
020-103316-07 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.