Chocolate3 Choc mate 2, Руководство пользователя

Страница: 40 / 88

Page 40
5.6. Pre-dosing
Open the print head and insert the wire on the front
of the cartridge about 5mm into the chocolate.
Close the print head (1) completely.
Initially there is still air between the surface
of the chocolate and the piston. This must es-
cape completely before printing.
You can move the piston down quickly until
the first chocolate comes out of the nozzle.
After that, you should only proceed in slow
mode.
Initially, you can proceed in larger steps. As
soon as the piston gets closer to the chocola-
te, the steps should become smaller.
Navigate to Home -> Pre-dosing .
Move the piston down until the first chocolate comes
out.
Remove the wire by pulling it upwards.
Now slowly dispense another 1-2 mm of chocolate
from the cartridge until an even flow of chocolate is
ensured.
End the process with „Done“ and a retraction will be
performed.
If the process is cancelled with Cancel , no retraction
is carried out.