Chipkin™
VeederRoot® Gateway User Manual
3381 Cambie Street, #211
© 2018 Chipkin Automation Systems
Vancouver, BC, Canada, V5Z 4R3
All rights reserved
1-866-383-1657
Page 20 of 67
Figure 4.1-9 - Sensor Configuration
In this part of the form, you can configure up to 10 sensors. As mentioned above, if the VeederRoot®
panel contains more then you must use the Advanced Configuration.
-
Name
–
The
sensor’s
name, this field is only used internally in the gateway.
-
Address
–
The
sensor’s
address in the VeederRoot® panel. If the Sensor has address 1-9, you
must type 01
–
09 as addresses are 2 digits.
-
Suffix
–
This is the name that gets appended to the BACnet data point. This usually is the same
as the Name column entry.
-
Type
–
The type of sensor. The default is Liquid Sensor
Vacuum Sensor Configuration
Figure 4.1-10 - Vacuum Sensor configuration
In this part of the form, you can configure up to 2 vacuum sensors. As mentioned above, if the
VeederRoot® panel contains more then you must use the Advanced Configuration.
-
Name
–
The sensor’s name, this field is only used internally in the gateway.
-
Address
–
The sensor’s address
in the VeederRoot® panel. Addresses are 2 digits as above.
-
Suffix
–
This is the name that gets appended to the BACnet data point. This usually is the same
as the Name column entry.
