Chino IR-CA series, Инструкция по эксплуатации

Страница: 33 / 36

INST.No.INE-454-P2 Software Ver.1.2
-30-
6.1 Starting up modes
Keys Screen Remarks
Paragraph
(Power on)
Measurement
mode
Temperature measurement
and parameter programming
in the operator mode
1
3
Press SEL and ENT keys simultaneously
in measurement mode screen. Engineering
mode Parameter programming in
the engineering mode
2.2
4
Press SEL, and ENT keys simultaneously
for 2 seconds in the measurement mode.
Key lock
Locking/release of function
keys
4.13
6.2 Screens
Screen Outline
Measurement
mode
∙
Measurement starts by power on.
∙
By pressing SEL key, the screen moves to the parameter programming screen (for
emissivity value, signal modulation, alarm and other parameters) in the operator mode.
(Ref. [3 Operator mode])
∙
The screen automatically returns to the measurement mode screen when the programming
up to [3.5Alarm programming] is completed or if any key is not pressed for 1minute.
Engineering
mode
∙
By pressing SEL and ENT keys simultaneouly, the screen moves to the parameter
programming screen (for analog output scaling, analog dummy output, hold function,
analog output correction, optional analog input, optional communications and other
parameters) in the engineering mode. (Ref. [5 Engineering mode])
∙
The screen automatically returns to the measurement mode screen when the programming
up to [4.10 Analog output correction programming] is completed (except the thermometer
with optional specifications) or if any key is not pressed for 1minute.
Key lock
∙
The key lock is used not to change the parameters being programmed.
∙
By pressing SEL, and ENT keys simultaneously for 2 seconds in the measurement
mode, the function keys are locked.
∙
For releasing, pressing SEL, and ENT keys simultaneously for 2 seconds again.
(Ref. [4.13 Key lock])
7.1 Parameter programming/selection (operating mode)
Parameter item Sub display Parameter Default
Paragraph
Emissivity
ε
(Sub marker)
1.999 to 0.050 1.000
3.1
Automatic
emissivity calculation Auto 0 to 6280ºC Minimum value of
measuring range
3.2
Signal modulation mode Modu dELy
、
PEAk dELy
3.3
Modulation degree *1 tAu
dEc 0.0 to 99.9 (second) or
0.00 to 99.9 (second)
0, 2, 5, 10ºC (ºF)/second 0.0 second
0ºC/second
3.4.1
3.4.2
Alarm type A.Mod no: Alarm disable
Hi: High alarm
Lo: low alarm Hi
3.5.1
Alarm setpoint
ALM 0 to 6280ºC Maximum value of
measuring range
Minimum value of
measuring range
3.5.2
*1: The parameters for the modulation degree differ by the signal modulation mode selection.
(Ref. [6.4.3 Signal modulation mode selection.])
6. List of starting up modes
7. Parameter programming/selection