INST.No.INE-454-P2 Software
Ver.1.2
- 12 -
4.3.3 Peak hold reset time programming
(It is necessary to program the reset time when the peak hold is selected in [4.3.1 Hold function type
selection] and then “
in
” (internal reset) is selected in [4.3.2 Peak hold reset type selection].)
4.4 Measurement unit selection
This mode is for the selection of the measurement unit for measured temperature.
Tb CONT MEM PEAK
AL
AH
C
F
ε
•
The programmable range is
0.0
to
99.9
(second).
•
The default value is
0.0
second.
Remarks
Main display
Sub display
Tb CONT MEM PEAK
AL
AH
C
F
ε
[ ºC ]
Main display
Sub display
[Measurement units]
C
:
ºC
F
:
ºF
The default is
C
(ºC)
R e m a r k s
Tb CONT MEM PEAK
AL
AH
C
F
ε
[ ºF ]
Main display
Sub display
4. Engineering mode
1) After the selection of “
in
” (time reset), press
SEL
key until
“
r.tim
” (programming screen of peak hold reset time) appears
in the sub display
as shown in the right figure.
2) By pressing
key, the most significant digit of the main
display will blink.
3) Use
or
key to program the desired value.
4) To shift to the next lower digit, press
key.
The next lower digit will blink.
5) Repeat the above procedure of (3) and (4) up to the least
significant digit for programming (4 digits).
6) To activate this programming, press
ENT
key.
Then, the programmed value is outputted as a dummy output.
1) To select the measurement unit, press
SEL
key in the
engineering mode screen until “
unit
” appears in the sub
display
as shown in the right figure.
2) By pressing
key, “
C
” or “
F
” will blink in the main display.
3) Use
or
key to select the desired unit.
4) To activate this selection, press
ENT
key.
