Installation Instructions
TIL1X2UU / TIL1X3UU / TIL1X4UU / TILVABUU
7
INSTALLATION
Adding Vertical Connector Kit
NOTE:
If more LED screens will need to be added to the top or
bottom of the screen configuration, add TILVABUU
vertical connector kit to top or bottom of wall mount
using the following instructions. If you are NOT adding
the TILVABUU connector kit, proceed to
Installing
First Mount
section.
IMPORTANT ! :
Install the vertical connector kit
BEFORE the mounts are attached to the wall.
If Starting LED Wall Installation With the Top Row
NOTE:
If you’re starting the installation at the top of the LED
video wall, the vertical connector brackets should be
attached to the
BOTTOM
of the mounts to create the
top row and each successive lower row.
1.
Slide the vertical connector (L) up from the bottom of the
mount, and attach with two 1/4-20 x 1/2" button head cap
screws (M) per vertical connector. (See Figure 2)
2.
Loosely install one 1/4-20 x 1/2" Phillips pan head screw (L)
in the lower screw hole at the bottom of each vertical
connector (L). (See Figure 2)
Figure 2
3.
Hang the open slot of the lower mount onto the partially
installed button head screw (M). (See Figure 2)
4.
Tighten both lower button head screws (M). (See Figure 2)
If Starting LED Wall Installation With the Bottom Row
NOTE:
If you’re starting the installation at the bottom of the
LED video wall, the vertical connector brackets should
be attached to the
TOP
of the mounts to create the
bottom row and each successive upper row.
1.
Slide the vertical connector (L) down from the top of the
mount, and attach with two 1/4-20 x 1/2" button head
screws (M) per vertical connector. (See Figure 3)
2.
Loosely install one 1/4-20 x 1/2" button head screw (M) in
the lower screw hole at the top of each vertical connector
(L). (See Figure 3)
3.
Hang the open slot of the upper mount onto the partially
installed button head screw (M). (See Figure 3)
4.
Tighten both upper button head screws (M). (See Figure 3)
Figure 3
(M)
(L)
Top
mount
Lower
mount
Hang open slot onto
partially installed button
head screw (M)
(M) x 2
1
2
3
(M) x 2
4
1
3
(M) x 2
(L)
2
(M)
Upper
mount
4
(M) x 2
3
Open slot
