Installation Instructions
TIL1X2UU / TIL1X3UU / TIL1X4UU / TILVABUU
11
14. Drill pilot holes in centerline of lower slots (see Table 1 for
size) and follow fastener information (appropriate for wall
type) located in Table 1. (See Figure 11)
15. Double check the level of the mount along the side of the
mount. (See Figure 11)
16. Fully tighten the 5/16 x 2-1/2" lag screws (F) through the 5/16"
fender washers (K). (See Figure 11)
Figure 11
17. Using a level on the front of the mount in various places, use
a 1" deep well socket to adjust the leveling feet on the mount
until the mount is plumb or even with something that is being
used as a reference point. (See Figure 12)
CAUTION:
Over-torquing may cause damage. Do NOT
use a drill to make the depth adjustment.
Figure 12
16
(K) x 2
14
x 2
15
(F) x 2
Just a tip -
After the first mount is installed, it
may be easier to adjust the plumb at this time. If a
lot of adjustment is going to be necessary it’s best
to adjust it right away to avoid any twist or tension
on the mount.
Leveling feet
locations
17
