Installation Instructions
Models: MSP-TDKCG110 & MSP-TDKCY220
9
DISPLAY INSTALLATION
ALL MOUNTS
1.
Ensure Centris bracket is able to swivel and tilt easily,
yet still be tight enough to hold display in desired
position (See Figure 10). Adjust as required before
proceeding. See "ADJUSTMENT" for detail.
Figure 10: Centris Bracket Orientation
2.
Rotate the Centris bracket so that the 100mm x
100mm mounting cutouts are on top (See Figure 10).
3.
Proceed to:
•
"MOUNTS REQUIRING SPACERS" if your
display has a recessed mounting hole cavity, and
the Centris bracket will not fit into that cavity (See
Figure 11), or to
•
"MOUNTS NOT REQUIRING SPACERS" for all
other configurations.
MOUNTS REQUIRING SPACERS
IMPORTANT ! :
Spacers (150) are used only if your
display has a recessed mounting hole cavity, and the
Centris bracket will not fit into that cavity (See Figure 11).
1.
Carefully place display face down on protective
surface.
2.
Place four spacers (150) over each of the mount
holes on the back of the display (See Figure 11).
Figure 11: Install Spacers and Screws
3.
Pick up and orient the mount (10) or arm assembly
(30), as applicable, so that the mounting holes in the
Centris bracket are aligned with the holes in the
spacers (150) (See Figure 11).
CAUTION:
Using screws of improper size may
damage your display! Proper screws will easily and
completely thread into display mounting holes.
4.
Using Phillips screwdriver, install four screws (140)
through the mounting holes/cutouts in Centris
bracket, through the spacers (150), into the display
(See Figure 11). Tighten all four screws (140). Do not
overtighten!
5.
For MSP-TDKCY220 Only: Repeat Steps 1-4 for
second display.
6.
Continue with "MOUNT INSTALLATION" (Edge or
Grommet, as applicable).
Centris
Bracket
100mm x 100mm
Mounting Cutouts
10 or 30
140
(4 places)
Centris Bracket
150
(4 places)
Recessed
Cavity
