Installation Instructions
Models: MSP-TDKCG110 & MSP-TDKCY220
7
MULTI-DUAL ARM ASSEMBLY
(MSP-TDKCY220 ONLY)
1.
Insert pin (90) into Y-connector upper bore in mount
(20) (See Figure 7).
Figure 7: Multi-Dual Arm Assembly
2.
Install washer (110) or spacer (100), as desired, on
pin (90) (See Figure 7).
NOTE:
Washer (110) will lock arm assembly (30) to Y-
connector. Spacer will allow limited movement of
arm assembly (30) relative to Y-connector,
dependent upon tension of screw (60).
3.
Insert arm assembly (30) on pin (90) (See Figure 7).
4.
While holding nut (120) in lower bore of Y-connector,
insert screw (60) through washer (80), washer (70),
washer (80), arm assembly (30), pin (90), and Y-
connector, into nut (120) (See Figure 7). Do not
tighten screw (60) at this time.
CAUTION:
Improper positioning of arm assembly (30)
may result in failure of mount and subsequent damage
to displays. Do NOT position either arm assembly (30)
in gray shaded area.
5.
Position arm assembly (30) within UNSHADED area
as shown (See Figure 8). Using hex key (210),
tighten screw (60) as required to maintain position.
Figure 8: Allowable Arm Area
6.
Repeat Steps 1. through 5. for second mount arm
assembly (30).
7.
If desired, proceed to "MULTI-DUAL ARM
MODIFICATION." Otherwise, proceed to:
•
"CABLE MANAGEMENT" if your displays
were
previously
installed, or to
•
"DISPLAY INSTALLATION" if your displays
were
not
previously installed.
30
60
80
70
80
110 or
100
90
Y-connector
20
NOTE: All parts
same for both sides.
120
DO NOT POSITION EITHER
ARM IN GRAY SHADED AREA
ALLOWABLE
ARM AREA
