Installation Instructions
FCA623
7
Display Installation
1.
Place display face down on a soft, non-abrasive surface.
NOTE:
For best access, route display cables through columns
prior to display installation. See Cable Management
section for details.
CAUTION:
Using screws of improper diameter may
damage your display! Proper screws will easily thread into
display mounting holes.
2.
Select screw
diameter
by examining hardware (HA-HC and
HF-HH) (6mm or 8mm) and comparing with mounting holes
on display. (See Figure 7)
3.
Select spacers:
•
If mounting holes are not recessed and interface
brackets (A and B) can lay flat against display,
then no spacers are required.
•
If mounting holes are recessed, or if protrusions
prevent brackets (A and B) from laying flat, then
spacers (HE) must be used.
CAUTION:
Using screws of improper length may damage
your display! Proper screws will have adequate thread
engagement without contacting bottom of display mounting
holes.
4.
Select screw
length:
(See Figure 7)
•
Using your hand, insert SHORTEST length screw
of selected diameter (HA or HF) through 1/4”
washer (HD), bracket (A or B), selected spacer
(HE, if required), into display mounting hole. Do
NOT thread screw into hole at this time.
•
Proper screw length requires base of screw head
to protrude above flat washer a
distance equal to
or greater than the screw diameter.
If screw
length is inadequate, select longer screw. Select
shortest
screw which will protrude the required
distance.
5.
Use selected screws (HA-HC or HF-HH), washers (HD) and
spacers (HE), if necessary, to connect interface brackets (A
and B) to back of display. Make sure diamond on interface
brackets is even with center of display. (See Figure 7)
Figure 7
(HE) x 4, if necessary
(A)
(B)
(HA-HC or HF-HH) x 4
5
(HD) x 4
Содержание FCA623
Страница 10: ...FCA623 Installation Instructions 10...
Страница 11: ...Installation Instructions FCA623 11...