Chicago Pneumatic LBG 804, Инструкция по безопасности и эксплуатации

Страница: 12 / 20

4. Set the switch to “ON” position.
OFF
ON
ON
5. Press the primer until the fuel can be seen in the
fuel return pipe.
6. Pull the starter rope to start the engine.
A
7. Immediately open the choke if it was closed and
allow the engine to warm up for a few minutes.
8. Increase the engine speed with the control lever.
Stopping
1. Reduce the speed by turning the control lever
to the “OFF” position.
2. Set the switch to the “OFF” position.
OFF
ON
OFF
3. Close the fuel valve.
NOTICE The vibration decreases with the drop of
engine speed and stops completely when the engine
is switched off.
Operating
1. Spray form oil under the beam to stop it from
sticking to the concrete.
2. Place the beam at the beginning of the first
section.
3. Start the machine.
4. Turn the handle link to obtain the optimum
beam angle on the concrete surface.
5. Adjust the vibration frequency according to the
fluidity of the concrete to obtain the desired
result.
6. Position the handle link on the shoulder.
7. Slowly walk backwards pulling on the beam.
The footprints are removed by the vibration from
the beam.
9800 1635 01 | Original instructions 12
LBG 804 Safety and operating instructions