Chicago Pneumatic LBG 804, Инструкция по безопасности и эксплуатации

Страница: 11 / 20

Transport
Lifting the machine
The beam is equipped with a lifting handle in the
front. The operating handle is disassembled to save
space when transporting.
1. After transporting fit the handle into the handle
link (A).
2. Lock the handle and link firmly together using
the screw, nut and washers at position (B).
A
B
♦
Close the fuel valve before transporting.
♦
Keep the engine vertical to prevent the fuel from
spilling. There is a risk for ignition of leaked or
vapourised fuel.
Operation
Preparations before
vibrating
♦
Clean and inspect the machine and its functions.
♦
Check for leaks and damage.
♦ Do not smoke, stand near a flame or another
potential danger when refuelling.
♦
When refuelling stop the motor and remove the
fuel cap.
♦
Refuel only with petrol.
♦
Close the fuel valve before refuelling.
♦ Always use a filter when refuelling.
♦
Wipe up any spilled fuel before starting up the
motor.
♦
Do not operate the motor in an area with
insufficient ventilation.
♦ Make sure that no flammable material comes in
contact with the exhaust.
♦ Check the fuel level.
♦
Check the oil level and make sure that it is toped
up.
Adjusting the work angle
1. Slide the beam on the surface of the concrete.
2. Simultaneously turn the handle link in the
counter clockwise direction.
3. Position the handle link on the shoulder.
4. Pull the beam backwards.
5. Simultaneously turn the handle link to adjust
the work angle so the edge of the beam closest
is slightly raised.
Start and stop
Starting
1. Open the fuel valve.
2. If the engine is cold, close the choke.
3. Check that the engine speed lever is set to idle.
A
B
11 9800 1635 01 | Original instructions
Safety and operating instructions LBG 804