SKU 42933
For technical questions, please call 1-800-444-3353.
Page 18
Slide the stock to be ripped into the
9.
cutting area and verify that it slides
easily beneath the Safety Guard,
Anti-kickback Arm, and (optional)
Spreader Plate, and there is no
wobble space. Remove stock from
cutting area.
Press the green Switch (122),
10.
squeeze the handle Trigger (93) (mo-
tor starts), and push up on the Lock
On Button.
From the side of the machine, feed
11.
the stock into the Saw Blade (against
its rotation) using a (long) push stick.
WARnIng: Do not use your hand to
push the stock through the Saw
Blade. Do not reach around the
Saw Blade while it is running. Seri-
ous injury can occur to hands and
arms.
When the cut is complete, and before
12.
removing the stock, squeeze the Trig-
ger or pull down on the Lock On But-
ton, press the red Switch, and wait
until the saw blade stops completely.
Out-Rip cutting
Out-ripping is done when the in-rip posi-
tion will not permit a wide enough cut. This
function moves the Saw Blade to the front
of the machine. This operation is the same
as in-rip cutting (previously described),
with the exception that the Pivot Yoke is
turned so that the Handle is on the right
side of the machine (opposite of the in-rip
position).
Adjust the Saw Blade for In-rip cutting
1.
as described on previous page.
Loosen the Bevel Lock Knob (71) and
2.
pull out the Bevel Index Knob (74).
Turn the motor assembly clockwise
3.
or counterclockwise, selecting the
desired angle (variable or indexed,
i.e., 45°).
Tighten the Bevel Lock Knob (71) and
4.
push in the Bevel Index Knob (74).
Press the green Switch (122),
5.
squeeze the handle Trigger (motor
starts), and push up on the Lock On
Button.
From the side of the machine, feed
6.
the stock into the Saw Blade (against
its rotation) using a (long) push stick.
WARnIng: Do not use your hand to
push the stock through the Saw
Blade. Do not reach around the
Saw Blade while it is running. Seri-
ous injury can occur to hands and
arms.
When the cut is complete, and before
7.
removing the stock, squeeze the Trig-
ger or pull down on the Lock On But-
ton, press the red Switch, and wait
until the saw blade stops completely.
