15
3. ASSEMBLY INSTRUCTIONS, PREPARATION, INSTALLATION
3.5
The Mountage Of The Connection Tool To The Output Shaft
For the mountage of the output shaft tools look at the schema below.
1=
Connection
unit
A=
False
B=
True
1)
The gear unit shaft end
2)
The axial bearing
3)
The connection tool
To prevent high radial forces: the gear and sprocket
must be mounted as seen in shape B.
For the mounting of the connection tools only pulling device must be used. For the position adjustment the
bearing strip which is at output shaft end must be used.
NOTE!
The belt and pulleys, couplings, gears and etc. Must not be installed with hammering to
the shaft end. Otherwise there could be a damage in body, bearings and shaft. In belt and
pulleys, the rightness of the belt voltage must be paid attention. (suitable to the producer's
data). For the not emerging of disallowed radial and axial forces, balance adjustment of the
connection tool must be made.
NOTE!
With smearing a little amount of grease or heating the connection tool in a short - time
(80….100), the mounting easiness may be provided.
3.6
The Mountage Of The Couplings
While the couplings are mounting, it's balances must be made suitable to the datas of the producers. Must be
implemented with suitable clamping device. Before mounting with the smearing of corrosion oil material to the
solid output shaft/ hollow shaft, mounting and demounting processes may be easened.
a.
Maximum and minimum distance
b.
Axial displacement
c.
Angular displacement
a
c
A basical clamping device example
d
e
b
A -
The solid output shaft
b -
The coupling
c -
The washer
d -
The nut
e -
The stud
ATTENTION!
The belt-pulley, chain and gear drives must be protected from the contact of the external
effects.
a
b
c
