Chiaravalli CHPL Series, Инструкция по установке, обслуживанию и эксплуатации

Страница: 15 / 41

12
3. ASSEMBLY INSTRUCTIONS, PREPARATION, INSTALLATION
3.1 Prerequisites Of Assembly
Take into the consideration which listed below;
●
The informations placed on gear unit with motor in accordance with current network voltage.
●
There could be no damage in the gear unit.
At standard gear units;
● The ambient temperature should be fitted temperature values given in the 'Lubricant'
part.
ATTENTION!
The Gear unit must not be mounted in the ambient conditions listed below.
- Explosive atmosphere, high corrosive and/or oils, acids, gases, steams, radiation
- Places directly contacted to the food
At special applications the configuration of gear unit/gear unit with motor are
realized convenient to the ambient
conditions. Output shafts, processed surfaces, corrosion preventive material on the solid shaft / hallow shaft,
jerks etc. must be cleaned.
Extensive usage-solvent must be used. The solvent should not be contacted to the bearing houses and sealing
components.
In the abrasive ambient conditions, both output shaft, sealing components must be protected to the wearing
Connection flanges must be attached to the hallow shaft/solid shaft according to DIN 332.
The situations where the wrong direction of rotation could caused to damages and dangers, before the mounting,
the test work should implemented to the gear unit so the right direction of rotation could be determined and
must got into the secure for the next operating.
In the one-way locked gear units, nibs are placed at the entry and exit side of the gear unit. The ends of the
nibs shows the direction of rotation of the gear unit. During the motor connection and motor-operating with the
help of magnetic field, the gear unit must be operated just at the direction of rotation.
ATTENTION!
In the one-way locked gear units, the gear unit must be operated at the direction of lock
rotation, otherwise the damage could be occured.
Around the mounting position, there must be sured that there are not any materials fused to metal, lubricating
tool or elastomers which causes corrosion or will not be emerged.