Installation Procedure
Note:
Pre-Drill holes with 7/32 or 5.6
mm drill before installation of service screw. As noted from original part.
1.
Install the screws for the extension panel bracket
(1). Refer to
Sheet Molded Compound (SMC) Panel Bonding
.
2.
Install the screws for the floor panel bracket
(1). Refer to
Sheet Molded Compound (SMC) Panel Bonding
.
Note:
Recommended wire alloy is 5554 and wire size is 1
mm (0.035
in). The shielding gas is 100 percent Argon.
3.
Using a P-MIG welder, stitch weld the cast rail section
(1) to the center rail duplicating the factory welds.
