ASSEMBLY & SETUP
This section will cover the basics in assembly and setup. We recommend you complete assembly in the
order in which it is presented to achieve the best results.
HANDWHEEL
The handwheel for the apron must be installed.
Figure 5.
Secure the handle with a screw driver.
1.
Remove the acorn nut and washer from the cross feed
Lead Screw.
2.
Slide the handwheel onto the cross feed
Lead Screw
. Note the key way that is in the bore of the
handwheel and orient it so it aligns with the key on the cross feed
Lead Screw.
3.
Secure the handwheel with the acorn nut and washer.
4.
Secure the handle for the handwheel with a screw driver as in
Figure 5.
HAND CRANK
The hand crank for the longitudinal manual feed must be installed.
1.
The end of the
Lead Screw
has a small hole that is crossdrilled near its end. The hand crank has a
similar hole drilled into the edge of the centre ball. Orient these holes to each other and slide the hand
crank onto the end of the shaft.
2.
Rotate the hand crank on the shaft until the holes align.
3.
Place the 4mm roll pin into the hole as in
Figure 6
and drive it in with a hammer.
Chester UK Model B
5
