ChemoMetec NucleoCounter, Руководство пользователя

Страница: 35 / 76

5 Operation of the NucleoCounter
18
5.3.2 Result presentation
The analysis will occur after a few seconds and the fluorescent
image is recorded. Once recorded, the image is analysed by the
instrument’s internal software. Upon completion of the
analysis, the result is shown on the display. The entire
process takes approximately 30 seconds.
5.3.3 External computer
If an external computer with the NucleoView software installed
on it is connected, the results and the recorded fluorescent
image can be viewed using the NucleoView software.
After the measurement is completed the cassette can be safely
removed (see section 5.2). Sometimes, however, the complete
process described above may be interrupted. Please familiarize
yourself with possible error handling of the NucleoCounter
presented in chapter 8.
5.4 Result display
Following a successful analysis, the cell density will be
displayed on the display screen. Figure 13 shows an example of
results as given on the display of the NucleoCounter
instrument.
Cells/ml:
1.234 x 10E6
Figure 13. Cell density of the cell lyzate, presented in
Result mode 3.
5.4.1 Result mode
The NucleoCounter allows the results to be presented using one
of three different representations of the results. In the
default display mode (mode 3) the result is displayed with
number of digits corresponding to full representation of the
number of cells per µl (with 1, 2, 3 or 4 digits). An overview
of the representations, mode 2-4, is shown below. Mode 0 and 1
are not available.