ChemInstruments HLCL-1000, Руководство по эксплуатации

Страница: 3 / 19

ASSEMBLY & INSTALATION
The HLCL-1000 weighs over 160 pounds; DO NOT attempt to move it by yourself.
Multiple people should always be used whenever the HLCL-1000 needs to be moved.
1. Remove the HLCL-1000 from the crate and set on a sturdy surface.
2. The feet on the bottom of the HLCL-1000 may be adjusted by turning clockwise or
counterclockwise. Adjust the feet until the unit is level.
3. Unwrap the two brake unwind cores and place them on the top of the unwind stands.
4. Place the two Teflon side dams in the reservoir.
OPTIONAL: The laminator portion of the HLCL-1000 can be removed from the unit and
placed further away from the coater if necessary. The laminator is held in place by four screws.
These screws are located on the bottom of the laminator and accessed through the top of the
laminator by removing the front and back guards. Each guard is held in place by two screws on
either side of the top of the guard.
1. Remove the screws and the guards to access the bottom of the laminator.
2. Once the guards are removed, you will expose the screws which mount the laminator to
the coater. Remove the screws. Store the screws in a safe place in case you wish to
reattach the laminator.
3. Remove the laminator from the coater.
4. Replace the guards on the laminator. The laminator should never be operated without
the guards in place.
5. The four extra feet included in with the HLCL-1000 are to be used on the bottom of the
laminator if it is separated from the coater. Using the included screws, mount one foot in
each corner of the laminator.
Assembly and installation diagram:
1. Brake unwind core ( pictured with
roll of film )
2. Brake unwind stand
3. Reservoir for Teflon side dams
4. Brake unwind core ( pictured with
roll of film )
5. Brake unwind stand
6. Guard
7. Screw securing guard
8. Screw securing guard
6
4
1
5
2
3
7
8
3