ChemInstruments HLCL-1000, Руководство по эксплуатации

Страница: 19 / 19

No air pressure. Air supply not connected.
Connect machine to
compressed air line and
make sure flow control
valve is open.
A – Tightening the drive coupling:
1. Remove the four #6-32 screws holding the contorl panel in place.
2. Carefully lift the panel upward and toward the back of the cabinet. Be careful not to pull
any wires from their connection.
3. Locate the coupling joining the bottom roll shaft and the motor output shaft.
4. Line the coupling’s set screws up with the flats on the shafts of the roll and motor.
5. To prevent further slippage, remove the set screws and put a drop of removable Loctite
(or comparable product) on the set screws before replacing them in the coupling.
6. Using a 3/32 Allen wrench, tighten the two set screws.
7. Replace the control panel, being careful not to pull or pinch any of the wires.
19