ChemInstruments HLCL-1000, Руководство по эксплуатации

Страница: 6 / 19

The machine must be plugged in to the appropriate electrical and air source in order to
operate safely and properly.
1. Mount the desired substrate on the brake unwind cores and mount the brake unwind cores
on the unwind stands.
2. Thread substrate from the unwind stand at the left of the machine through the coating
head.
3. Set the coating head to the desired thickness of the coating you would like to produce.
4. Thread substrate from both unwind stands through the laminator nip.
5. Turn on the coater.
6. Program the desired temperature for the top coating bar, bottom coating bar, and
reservoir.
7. Turn on laminator. (ON/OFF switch is located on the back of the laminator next to the
plug.
8. Set laminator controls: speed, pressure, and direction.
9. Place Teflon side dams in reservoir to the desired width you would like to make the
coating, and pour the pre-heated coating into reservoir.
10. Close laminator nip to produce coating.
The HLCL-1000 should be run until the reservoir is empty and a coating is no longer being
produced. To stop the HLCL-1000, open the laminator nip. After the HLCL-1000 has cooled to
ambient temperature, disassemble and thoroughly clean the coating head.
6