Electric Induction hobs Chef’s
EH-DIH386 & EH-MIX386
23
-
As for a timer already programmed, its remaining time is always indicated. The
dot on 7segment 20 is statically on to indicate the running of the timer (when left
time is more than 1 min),
-
when the timer is running and it’s left time is less than 1 min, then 7-
segment led 19 is off and 7-segment 20 display the left seconds.
If no setting is made within 10 sec (parameter) after selecting a timer (display
remains at „0.00“), the display changes automatically back to the blank
status (timer is OFF).
The last 59 sec prior to expiry of a timer are indicated on the display, which
shows the last seconds being counted down (countdown to setting off alarm).
During cooking zone timer is edited, it shows “0.01”~”9.59”. (It won’t show
“1”~”59” for the first 59 sec.)
13.4 Setting timer value
-
After selection of the timer the assigned timer indicator LED flashes as described
above. By touching the +/- keys (key 14 = minute -, key 15 = minute +) the
desired timer countdown cycle can be set.
-
Starting with the minute plus key, the timer display (20) will start out at “1” and
move up to “9.59”, accompanied by audible signal. In order to start again the Plus
key has to be released beforehand to be pressed again, then to “0.00”,
-
Starting with the minute minus key, the display value will start out at „0.30“ (normal
using of induction will not exceed 30 minutes) and move down to reach „0.00 “,
accompanied by audible signal. In order to start again the minus key has to be
released beforehand to be pressed again.
-
Setting can be made by holding the plus or minus key or, alternatively, by
single operations (touching: press, release, press, release etc.).
-
After timer time has been set (the timer time ≠ 0), press Key5 or wait for 10 sec,
the setting timer start to run. Timer settings precede over operating time
limitation when high cooking stages were selected.
Fig. 13: Select value timer by touching key "+" or "-".
