Checkpoint Evolve F10, Руководство по установке

Страница: 29 / 71

F10 Installation Manual Rev. *60
29 of 71
10. Route the coax cable through the L-shaped fitting and 3 inch piece Tubing (cut to length).
After antenna placement is finalized, apply PVC cement and secure the section of Tubing.
11. To prepare the coax cable, strip the outer insulator, then twist the conductor into a wire lead.
12. Next, cut the inner insulator flush with the outer and strip ¼ inch of the sheathing around the
inner conductor (above right). Ensure that conductors are short enough to prevent touching.
13. Using a small screwdriver, gently hold the connectors open and then insert the coax wire
leads. Repeat for the second coax cable. Ensure that both inner and outer conductors match.
14. Make the antenna wiring connections to the matching board as shown (or refer to Table 4.1).