Check Point Pointsec PC, Руководство по установке

Страница: 17 / 44

Review precheck.txt
Chapter 1 Before You Install Pointsec PC 11
Precheck Settings
The following sections describe the settings you can configure in
precheck.txt
.
General Settings
Table 1-1 General Settings
Setting Description
AddFilter=Yes
This is a legacy setting for Windows Pointsec PC driver
installation. It is no longer used.
SupportMultiProcessor=Yes
The value can be
Yes
or
No
. If the value is set to No, the
installation will be terminated if either more than one
processor or multithreading is detected. The default value is
Yes.
AbortOnWindowsXP=No
The value can be
Yes
or
No
. If the value is set to Yes, the
installation will be terminated if Windows XP is the operating
system on the computer on which Pointsec PC is being
installed. The default value is No.
AbortOnDualBoot=Yes
The value can be
Yes
or
No
. The default value is
Yes
which
will cause Pointsec PC to terminate an installation on a dual
boot system.
IgnoreOldInstallation=No
Set this setting to
Yes
to enable support for re-installing on
selected volumes while keeping old installations on other
volumes.
Note: You must use the same user accounts in both
installations.
Note: A re-installation of the boot volume requires all volumes
to be protected by Pointsec PC.
ChainToMBR=
This setting specifies which boot record Pointsec PC will load
and start immediately after Pointsec PC preboot logon:
Yes = Pointsec PC loads and starts the master boot record.
Yes is the default.
No = Pointsec PC loads and starts the partition boot record.