Monitoring and Configuration
Check Point 61000 Security System Getting Started Guide R75.40VS for 61000 | 86
•
SNMP alert parameters
Define one or more SNMP managers to get SNMP traps sent from the Security Gateway. For
each manager, configure these parameters as prompted:
•
SNMP manager name
- Name for your SNMP manager (unique).
•
SNMP manager IP
- Manager IP address (trap receiver).
•
SNMP version
- SNMP version to use (v2cv3).
•
SNMP v3 user name
- If using SNMP v3 authentication, you must configure this.
•
SNMP v3 engine ID
- Unique SNMP v3 engine ID used by your system.
Default = [0x80000000010203EA].
•
SNMP v3 authentication protoco
l - MD5 or SHA.
•
SNMP v3 authentication password
- Privacy password.
•
SNMP v3 privacy protocol
- DES or AES.
•
SNMP v3 privacy password
- Privacy password.
•
SNMP user text
- Custom text for the SNMP trap messages.
•
SNMP community string
- Community string for the SNMP manager.
Note
- Some parameters do not show, based on your settings.
•
Log alert parameters
•
There are no configurable parameters for log alerts.
Event types
You can select one or more event types:
•
One event type.
•
A comma-delimited list of more than one event type.
•
all
event types.
-----------------------------------
1 | SGM State
2 | Chassis State
3 | Port State
4 | Pingable Hosts State
5 | System Monitor Daemon
6 | Route State
7 | Diagnostics
Hardware Monitor events:
8 | Fans
9 | SSM
10 | CMM
11 | Power Supplies
12 | CPU Temperature
Performance events:
13 | Concurrent Connections
14 | Connection Rate
15 | Packet Rate
16 | Throughput
17 | CPU Load
18 | Hard Drive Utilization
19 | Memory Utilization
Alert Modes
•
Enabled
- An alert is sent for the selected events.
•
Disabled
- No alert is sent for the selected events.
