Step 6: Installing the Software
Check Point 61000 Security System Getting Started Guide R75.40VS for 61000 | 56
Example:
Item
Description
1
2
USB port
One of two latches for extracting and inserting the SGM.
2.
Connect the supplied DB9 serial cable to the console port on the front of the left-most SGM on
the 61000 Security System.
3.
Connect to the left-most SGM using a terminal emulation program.
4.
Reboot the SGM by partially sliding it out and immediately pushing it back in place:
a)
Loosen the thumb screws at the top and bottom of the SGM.
b)
Open the latches at the top and bottom of the SGM.
c)
Fasten the latches.
d)
Tighten the thumb screws.
5.
When the first screen shows, select
Install Gaia on the system
and press
Enter.
6.
You must press
Enter
in 60 seconds, or the computer will try to start from the hard drive. The
timer countdown stops once you press
Enter
. There is no time limit for the subsequent steps.
7.
Press
OK
to continue with the installation.
After the installation, the 61000 Security System begins the boot process and status messages
show in the terminal emulation program.
