CHD 8-427, Руководство по установке

Страница: 15 / 16

Korg Polysix MIDI Interface Korg Polysix MIDI Interface Korg Polysix MIDI Interface Korg Polysix MIDI Interface
P6 P6 P6 P6----M M M M Installation Installation Installation Installation Manual Manual Manual Manual
8 88 8----427 / v. 1.00 427 / v. 1.00 427 / v. 1.00 427 / v. 1.00
Copyright © 2021 CHD Elektroservis. All rights reserved.
No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.
15
15 15
15
3 33 3 INSTALLATION TIPS INSTALLATION TIPS INSTALLATION TIPS INSTALLATION TIPS
3.1 3.1 3.1 3.1 MIDI INPUT AND OUTPUT MIDI INPUT AND OUTPUT MIDI INPUT AND OUTPUT MIDI INPUT AND OUTPUT
If you do not want to mechanically damage the panels of the instrument by drilling, you can use alternative
metod of the MIDI – IN / OUT sockets montage. You can lead out the MIDI cables through a slot on the
instrument cover (see fig. 3.1.1 for example). In that case, you will have to replace the delivered MIDI cables
with another ones equipped with cable type of the DIN sockets or plugs.
If you decide to install only MIDI-IN socket, the X4 connector (labeled “MIDI MIDI MIDI MIDI----OUT OUT OUT OUT”) on the interface board will
remain unused (see fig. 3.1.2).
Fig. 3.1.1 Fig. 3.1.1 Fig. 3.1.1 Fig. 3.1.1 Fig. 3.1.2 Fig. 3.1.2 Fig. 3.1.2 Fig. 3.1.2
X
4
"M
IDI-O
UT
"
3.2 3.2 3.2 3.2 RESET BUTTON AND INDICATION LED RESET BUTTON AND INDICATION LED RESET BUTTON AND INDICATION LED RESET BUTTON AND INDICATION LED
Fig. 3.2.1 Fig. 3.2.1 Fig. 3.2.1 Fig. 3.2.1
Installation of the reset button and indication LED isn’t
necessary as well. You don´t need to install this
bunched cables if you don’t want to damage the
instrument’s panel by drilling. In such case, the X5
connector (labeled “CTRL
CTRL CTRL
CTRL”) remains unused (see fig.
3.2.1). The interface operation is unaffected but you
have no optical info about the interface status and
reset of the interface must be executed by turning the
instrument off and on again or by MIDI commands
sent to the interface (see the Owner’s Manual of the
interface).
It is also possible to install only the indication LED or only the reset button on instrument’s panel:
For the indication LED only installation, cut-off black and both yellow wires of the bunched cables as shown on
fig. 3.2.2 and remove the reset button. Then connect the two free yellow wires together. If the reset button is
not installed, the interface operation is unaffected. The only limitation is that the reset of the interface can be
done only by turning the instrument off and on again or by MIDI commands sent to the interface (see the
Owner’s Manual of the interface).
X5
"
CT
RL
"