CHD 8-427, Руководство по установке

Страница: 10 / 16

Korg Polysix MIDI Interface Korg Polysix MIDI Interface Korg Polysix MIDI Interface Korg Polysix MIDI Interface
P6 P6 P6 P6----M M M M Installation Installation Installation Installation Manual Manual Manual Manual
8 88 8----427 / v. 1.00 427 / v. 1.00 427 / v. 1.00 427 / v. 1.00
Copyright © 2021 CHD Elektroservis. All rights reserved.
No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.
10
10 10
10
c) Place heat-shrink insulation tube
φ
2 mm (from the interface accessory) on wire Nr. 12 of the ribbon cable
and solder the wire Nr. 12 of the ribbon cable to previously freed wire Nr. 17 of CN12 (fig. 2.4.5).
d) Isolate the connection with the insulation tube and heat it (with a hot-flue pistol for example) until it shrinks
tightly to the wires (fig. 2.4.6).
Fig. 2.4.7 Fig. 2.4.7 Fig. 2.4.7 Fig. 2.4.7
e) Wires from Nr. 13 to Nr. 20 of the 20-core ribbon
cable are solderd directly to pads 5 to 12 of CN10
connector
4 44 4
as shown on fig. 2.4.7. Solder the wires to
these pads directly in parallel manner to original wires
leaded to the pads.
2.5
2.5 2.5
2.5 16
16 16
16----CORE RIBBON CABLE MOUNTING
CORE RIBBON CABLE MOUNTING CORE RIBBON CABLE MOUNTING
CORE RIBBON CABLE MOUNTING
The delivered 16-core ribbon cable is fitted with 16-pin
connector (fig. 2.5.1). It must be connected to several
pads at the KLM-366
5
55
5
board of the instrument (fig 2.5.2).
Fig. 2.5.1 Fig. 2.5.1 Fig. 2.5.1 Fig. 2.5.1
Fig. 2.5.2 Fig. 2.5.2 Fig. 2.5.2 Fig. 2.5.2
4
44
4
There is no physical connector on the KLM-371 board. There is only a row of soldering pads. But these pads are labeled as CN10 connector in
technical documentation of the instrument.
5 55 5
There are two a little different versions of the KLM-366 board. The installation process is the same for both old and new (KLM-366B) versions.