22
Mōveo™ XP
5- REMOVAL AND REPLACEMENT
Unplug the unit from the power source before
attempting removal or replacement procedures to
prevent electrical shock.
5.1 HAND CONTROL REMOVAL AND
REPLACEMENT
FIGURE 5.2
FIGURE 5.3
A. Part Number
......................................................80985
B. Equipment Required
• Flat Head Screwdriver
• Wire Cutters
1. Lock the caster on the table and unplug the
1. Lock the caster on the table and unplug the
table from the
table
from
the
Mains
Power..
NOTE:
NOTE:
Always remove the transfer cushion before
Always remove the transfer cushion before
working on the table.
working on the table.
2. Remove the tilt angle indicator and the side
2. Remove the tilt angle indicator and the side
panel using wire cutters or a flat head
panel using wire cutters or a flat head
screwdriver to pop up the center pin of the
screwdriver to pop up the center pin of the
black fasteners. Once the center pin is
black fasteners. Once the center pin is
raised, the fasteners can be easily removed.
raised, the fasteners can be easily removed.
Refer to Figure 5.1.
Refer
to
Figure
5.1.
NOTE:
NOTE:
When using wire cutters, be certain not to
When using wire cutters, be certain not to
cut through the center pin. The wire cutters
cut through the center pin. The wire cutters
should be used to grasp and raise the pin.
should be used to grasp and raise the pin.
Retain all
Retain all black fasteners
black fasteners for reinstallation of
for reinstallation of
the tilt indicator and the side panel.
the tilt indicator and the side panel.
3. Using a coin or flat head screwdriver,
3. Using a coin or flat head screwdriver,
turn the slotted screw on the controller
turn the slotted screw on the controller
cover counterclockwise to unlock. Remove
cover
counterclockwise
to
unlock.
Remove
the controller cover.
the
controller
cover.
Refer to Figure 5.2.
Refer to Figure 5.2.
4. Disconnect the hand controller from port
4. Disconnect the hand controller from port
#9.
#9.
Refer to Figure 5.3.
Refer to Figure 5.3.
5. Reverse these steps for installation of the
5. Reverse these steps for installation of the
new hand controller.
new
hand
controller.
FIGURE 5.1
PORT 9
FASTENER
